Connecting to WaveRunner 9000 by Teledyne in Python
WaveRunner 9000 oscilloscopes have the industry’s widest and deepest collection of tools, making it unbelievably powerful and MAUI with OneTouch makes measurement setup insanely easy, providing faster time to insight.
Device Specification: here
Manufacturer card: TELEDYNE
Teledyne LeCroy is an American manufacturer of oscilloscopes, protocol analyzers and other test equipment. LeCroy is now a subsidiary of Teledyne Technologies.
- Headquarters: USA
- Yearly Revenue (millions, USD): 5458.6
- Vendor Website: here
Demo: Measure signal width and phase with a Tektronix oscilloscope
Connect to the WaveRunner 9000 in Python
PROTOCOLS > SCPI
To connect to a WaveRunner 9000 Oscilloscope using Instrumentkit, you can use the following code:
This code imports the
instrumentkit module and uses the
open_visa function from the
ik.teledyne.MAUI module to connect to the oscilloscope. The IP address “192.168.0.10” is used as an example, and you should replace it with the actual IP address of your oscilloscope.
Once connected, you can perform operations on the oscilloscope, such as starting the trigger in automatic mode and printing the trigger state. Finally, you can close the connection to the oscilloscope using the
Note: This code assumes that you have installed the necessary dependencies and have the correct VISA backend configured.